- Please
examine whether the power wire is in good condition
and the bracked is provided and flow backwards with
the adhesive gun handled.
- The adhesives
gun must be pre-heated before using, please don't
place the adhesives gun erectly on the tables.
- Please
keep the surface of the hot-melt adhesives strip and
avoid pluging the mouth of guns up.
- During
the course of using the gun, if no gule comes from
the mouth of the gun, please check the heat radiation
of the gun;
- The
reason in abnormal heat radiation:
1 the power is not correctly inserted of the gun;
2 the gun is burned out for short circuit.
- The
reason in normal heat radiation:
1 When the mouth of the gun is pluged up by impurities,
please contact professional personnel to repair
it;
2 When the flowbackwards occur leading to widen
of the strip, you need to circumrotate the strip
for a circule , tear a small moiety to shuck off
the wider, continue to use it.
- Before
using the adhesive strip up, try your best not to
draw the adhesive strip from the adhesive gun
- When
flowbackwards occurs to the adhesive strip, please
stop using the gun. after the professional personnel
clean the refluent adhesives .
- Pleast
cut the power off on condition that the calefaction
time is more than 15 minutes and desuetude of the
gun.please contact with Dongguan Chengming Hot-melt
Adhesives Co.,Ltd , customer service tel: 0086-769-6319710
￡o0086-769-6319710
|
